Magigoo Pro Flex

• Appearance: clear-faint yellow liquid
• Consistency: low-med viscosity
• Solvent: water

Intended use:
To be used on FDM/FFF 3D printers with a heated bed on glass surfaces. Also works when applied on sheets e.g. Kapton, PEI and similar. To be used with flexible filaments.

Properties:
MAGIGOO® – Flex, acts as a thermally activated interfacial layer, allowing for better interactions, both at the micro and molecular level, between the printing bed and the printing materials. It is generally recommended to print according to the printing temperatures recommended by the filament supplier. The printing conditions vary between one printer and another.

To find the best temperature one could start from the lower end of the recommended settings and increase the bed temperature in 5 °C increments. This should be done with standardised calibration prints.

An additional benefit of MAGIGOO® – Flex, being thermally activated, is that it will enable the print to be easily removed upon cooling. Keep in mind that different printers, print surfaces or filaments will behave differently. Some flexible materials can also be removed by applying water around the printed part – we recommend that you take the build surface out of the printer prior to this step! After waiting for the water to penetrate between the part and the build surface and one can easily remove the part

Cleaning and re-applying between prints is recommended especially on longer prints or hard to print with materials.

Storage and Handling:
MAGIGOO® – Flex, should be stored in a cool dry place away from direct sunlight. After use MAGIGOO® – Flex should be stored in an upright position and with the cap on.

Excess MAGIGOO® – Flex on the nib can cause the applicator adhering to the cap. To prevent this, make sure no excess MAGIGOO® – Flex remains on the rim of the applicator after use.

If not capped the MAGIGOO® – Flex applicator will dry up. In such a case just rinse with water.